# set (git) module specific defines, but only if we are actually qtbase # do _not_ set them as the global toplevel configuration # we check for QT_REPO_MODULE_VERSION before defining it below; that will # ensure that when this file is included the second time in a toplevel buld # (directly by qtbase) we actually add the extra definitions if (NOT DEFINED QT_SUPERBUILD OR DEFINED QT_REPO_MODULE_VERSION) set(QT_EXTRA_INTERNAL_TARGET_DEFINES "QT_LEAN_HEADERS=1") endif() set(QT_REPO_MODULE_VERSION "6.5.0") set(QT_REPO_MODULE_PRERELEASE_VERSION_SEGMENT "alpha1") # Minimum requirement for building Qt set(QT_SUPPORTED_MIN_CMAKE_VERSION_FOR_BUILDING_QT_SHARED "3.16") set(QT_SUPPORTED_MIN_CMAKE_VERSION_FOR_BUILDING_QT_STATIC "3.21") # Minimum requirement for consuming Qt in a user project. # This might be different in the future, e.g. be lower than the requirement for # building Qt. set(QT_SUPPORTED_MIN_CMAKE_VERSION_FOR_USING_QT_SHARED "3.16") set(QT_SUPPORTED_MIN_CMAKE_VERSION_FOR_USING_QT_STATIC "3.21") # Policy settings for commands defined by qtbase. These will also be injected # into the top level policy scope of each Qt module when building Qt so that # modules have the same policy settings as qtbase by default. They can be # overridden by individual Qt modules in their own .cmake.conf files if needed. # # NOTE: These two values are also hard-coded in QtBuildInternalsConfig.cmake # because that file is used in-place by a superbuild, so there is no # opportunity for substituting the values from here. Keep both locations # in sync. set(QT_MIN_NEW_POLICY_CMAKE_VERSION "3.16") set(QT_MAX_NEW_POLICY_CMAKE_VERSION "3.21")