path: root/src/doc/src/devices/qtee-drive-cx.qdoc
diff options
authorTopi Reinio <>2016-09-01 10:43:52 +0200
committerTopi Reiniƶ <>2016-09-01 09:31:41 +0000
commit1812b8e95b8b27b0879c97e66fcda739b502f7aa (patch)
tree298eebca3ae0118a2b047864e50dcf564868b681 /src/doc/src/devices/qtee-drive-cx.qdoc
parent5e8ba4ae4db89cc898e021b430e00d13b0e83619 (diff)
Doc: Remove rest of the generic Qt for Device Creation doc files
These are moved to tqtc-boot2qt/doc repository. Change-Id: I8772597b684f292cfffe583e4eaa01679e7ec80b Reviewed-by: Topi Reiniƶ <>
Diffstat (limited to 'src/doc/src/devices/qtee-drive-cx.qdoc')
1 files changed, 0 insertions, 65 deletions
diff --git a/src/doc/src/devices/qtee-drive-cx.qdoc b/src/doc/src/devices/qtee-drive-cx.qdoc
deleted file mode 100644
index 439d2a4..0000000
--- a/src/doc/src/devices/qtee-drive-cx.qdoc
+++ /dev/null
@@ -1,65 +0,0 @@
-** Copyright (C) 2016 The Qt Company Ltd.
-** All rights reserved.
-** For any questions to The Qt Company, please use the contact form at
-** This file is part of Qt for Device Creation.
-** Licensees holding valid commercial Qt licenses may use this file in
-** accordance with the commercial license agreement provided with the
-** Software or, alternatively, in accordance with the terms contained in
-** a written agreement between you and The Qt Company. For licensing terms
-** and conditions see For further
-** information use the contact form at
- \page qtee-preparing-hardware-drivecx.html
- \previouspage qtee-installation-guide.html
- Take the following steps when preparing \l {}
- \note It is important that you repeat the steps in this section after you
- update \QAS.
- The image containing the \B2Q stack for the device, as well as the
- flashing tool are included in \QAS.
- \section1 Installing the \B2Q Image
- Connect the DRIVE CX board to the development host via USB, and set it in
- \e {recovery mode} by changing the position of J9 jumper on the board.
- Then, run the flashing tool:
- \badcode
- sudo 5.7/Automotive/tegra-t18x/flash-nvidia/
- \endcode
- After the installation is complete, replace the J9 jumper to its original
- position, and restart the device. After reboot, check that the automotive
- UI appears.
- \section1 Setting up USB Access
- \include b2qt-post-install-setup.qdocinc setting up usb access
- \section1 Configuring a Device Kit in Qt Creator
- After you have prepared the hardware, you must perform one final step
- to set up the development tools in Qt Creator for your device. Run the
- following command:
- \badcode
- 5.7/Automotive/tegra-t18x/toolchain/
- \endcode
- You are now ready to start developing for your device. For more information,
- see \l{Building and Running an Example}.