diff options
Diffstat (limited to 'src/doc/src/b2qt-post-install-setup.qdocinc')
| -rw-r--r-- | src/doc/src/b2qt-post-install-setup.qdocinc | 23 |
1 files changed, 11 insertions, 12 deletions
diff --git a/src/doc/src/b2qt-post-install-setup.qdocinc b/src/doc/src/b2qt-post-install-setup.qdocinc index d1a6f08..ef93b3f 100644 --- a/src/doc/src/b2qt-post-install-setup.qdocinc +++ b/src/doc/src/b2qt-post-install-setup.qdocinc @@ -74,22 +74,21 @@ //! [configuring device kit] //! [configuring network device] - After the hardware has been prepared, there are final steps required - to set up the development tools in Qt Creator for your device. - - To do so, connect your device to network via ethernet cable and launch - Qt Creator. Then, + After you have prepared the hardware, you must set up the development tools + in Qt Creator for your device. Connect your device to the network via an + Ethernet cable and launch Qt Creator. In Qt Creator: \list 1 - \li Go to \b{Tools > Options > Devices} - \li Click \b{Add...} - \li Select \b{Boot2Qt Device} and Click \b{Start Wizart} - \li Fill in name of the device and network address. Device address can be seen from - \e{Launcher Settings} when device is running \B2Q demo - \li Click \b{Finish}. + \li Select \b{Tools > Options > Devices > Add}. + \li Select \b{Boot2Qt Device} > \b{Start Wizard}. + \li Enter the device name and network address. You can check the device + address in the \e{Launcher Settings} when the device is running the + \B2Q demo. + \li Select \b{Finish}. \endlist - You also have to configure the right device to be used for each \b{Kit}. + You also have to configure the correct device to be used for each build and + run \e{kit}: \include b2qt-post-install-setup.qdocinc steps for device kit |