1 files changed, 68 insertions, 0 deletions
diff --git a/src/doc/src/devices/qtee-architech-tibidabo.qdoc b/src/doc/src/devices/qtee-architech-tibidabo.qdoc
new file mode 100644
index 0000000..a8b8214
--- /dev/null
+++ b/src/doc/src/devices/qtee-architech-tibidabo.qdoc
@@ -0,0 +1,68 @@
+/****************************************************************************
+**
+** Copyright (C) 2014 Digia Plc
+** All rights reserved.
+** For any questions to Digia, please use the contact form at
+** http://www.qt.io
+**
+** This file is part of Qt Enterprise Embedded.
+**
+** Licensees holding valid Qt Enterprise licenses may use this file in
+** accordance with the Qt Enterprise License Agreement provided with the
+** Software or, alternatively, in accordance with the terms contained in
+** a written agreement between you and Digia.
+**
+** If you have questions regarding the use of this file, please use
+** the contact form at http://www.qt.io
+**
+****************************************************************************/
+/*!
+    \target ArchiTech Tibidabo (embedded Linux)
+    \page qtee-preparing-hardware-tibidabo.html
+    \title Preparing ArchiTech Tibidabo
+    \previouspage qtee-installation-guide.html
+
+    Take the following steps to prepare a SILICA
+    \l{http://www.silica.com/product/architech-tibidabo.html}{ArchiTech Tibidabo} for \B2Q.
+
+    \note It is important that you repeat the steps in this section after you
+    update \SDK.
+
+    The images containing the \B2Q stack for ArchiTech Tibidabo are included
+    in \SDK, ready to be copied to an SD card.
+
+    \section1 Preparing an SD Card
+
+    An SD card of at least 1 GB capacity is sufficient.
+
+    \include detect-sd-card-device-name.qdocinc instructions
+
+    \section1 Installing the \B2Q Image
+
+    \include common.qdocinc wizard
+
+    First, ensure that no partitions on the SD card are mounted:
+
+    \include detect-sd-card-device-name.qdocinc unmount
+
+    Then, use the following command:
+
+    \badcode
+        cd <INSTALL_DIR>
+        sudo ./Boot2Qt-4.x/tibidabo-eLinux/images/deploy.sh /dev/<device_name>
+    \endcode
+
+    After the installation is complete, insert the SD card, power on the device and check that
+    the \B2Q welcome screen and/or demo appear.
+
+    \section1 Setting up USB Access
+
+    \include b2qt-post-install-setup.qdocinc setting up usb access
+
+    \section1 Configuring a Device Kit in Qt Creator
+
+    \include b2qt-post-install-setup.qdocinc configuring device kit
+
+    You are now ready to start developing for your device. For more information,
+    see \l{Building and Running an Example}.
+*/