diff options
Diffstat (limited to 'src/doc/src/devices/qtee-beagleboard-xm.qdoc')
-rw-r--r-- | src/doc/src/devices/qtee-beagleboard-xm.qdoc | 69 |
1 files changed, 69 insertions, 0 deletions
diff --git a/src/doc/src/devices/qtee-beagleboard-xm.qdoc b/src/doc/src/devices/qtee-beagleboard-xm.qdoc new file mode 100644 index 0000000..fae5725 --- /dev/null +++ b/src/doc/src/devices/qtee-beagleboard-xm.qdoc @@ -0,0 +1,69 @@ +/**************************************************************************** +** +** Copyright (C) 2014 Digia Plc +** All rights reserved. +** For any questions to Digia, please use the contact form at +** http://qt.digia.com/ +** +** This file is part of Qt Enterprise Embedded. +** +** Licensees holding valid Qt Enterprise licenses may use this file in +** accordance with the Qt Enterprise License Agreement provided with the +** Software or, alternatively, in accordance with the terms contained in +** a written agreement between you and Digia. +** +** If you have questions regarding the use of this file, please use +** the contact form at http://qt.digia.com/ +** +****************************************************************************/ +/*! + \target BeagleBoard-xM (embedded Linux) + \page qtee-preparing-hardware-beagleboard.html + \title Preparing BeagleBoard-xM + \previouspage qtee-installation-guide.html + \nextpage qtee-building-and-running.html + + Take the following steps to prepare a \l{http://beagleboard.org/hardware-xM} + {BeagleBoard-xM} for + \B2Q. + + \note BeagleBoard-xM is no longer supported in \SDK 3.0. It is still, + however, supported and tested under the previous 2.x versions. + + The image containing \B2Q stack for BeagleBoard-xM are included in \SDK, + ready to be copied to an SD card. + + \section1 Preparing an SD Card + + An SD card of at least 512 MB capacity is needed. + + \include detect-sd-card-device-name.qdocinc instructions + + \section1 Installing the \B2Q Image + + To write the image to the SD card, ensure that no partitions on the + SD card are mounted: + + \include detect-sd-card-device-name.qdocinc unmount + + Then, + + \badcode + cd <INSTALL_DIR> + sudo Boot2Qt-3.x/beagleboard-eLinux/images/deploy.sh /dev/<device_name> + \endcode + + After the image has been deployed, power on the device and check that + the \B2Q welcome screen and/or demo appear. + + \section1 Setting up USB Access + + \include b2qt-post-install-setup.qdocinc setting up usb access + + \section1 Configuring a Device Kit in Qt Creator + + \include b2qt-post-install-setup.qdocinc configuring device kit + + You are now ready to start developing for your device. For more information, + see \l{Building and Running an Example}. +*/ |