1 files changed, 0 insertions, 65 deletions
diff --git a/src/doc/src/devices/qtee-drive-cx.qdoc b/src/doc/src/devices/qtee-drive-cx.qdoc
deleted file mode 100644
index 439d2a4..0000000
--- a/src/doc/src/devices/qtee-drive-cx.qdoc
+++ /dev/null
@@ -1,65 +0,0 @@
-/****************************************************************************
-**
-** Copyright (C) 2016 The Qt Company Ltd.
-** All rights reserved.
-** For any questions to The Qt Company, please use the contact form at
-** http://www.qt.io/contact-us
-**
-** This file is part of Qt for Device Creation.
-**
-** Licensees holding valid commercial Qt licenses may use this file in
-** accordance with the commercial license agreement provided with the
-** Software or, alternatively, in accordance with the terms contained in
-** a written agreement between you and The Qt Company. For licensing terms
-** and conditions see http://www.qt.io/terms-conditions. For further
-** information use the contact form at http://www.qt.io/contact-us.
-**
-****************************************************************************/
-/*!
-    \page qtee-preparing-hardware-drivecx.html
-    \title NVIDIA DRIVE CX
-    \previouspage qtee-installation-guide.html
-
-    Take the following steps when preparing \l {http://www.nvidia.com/object/drive-cx.html}
-    {NVIDIA DRIVE CX} for \B2Q:
-
-    \note It is important that you repeat the steps in this section after you
-    update \QAS.
-
-    The image containing the \B2Q stack for the device, as well as the
-    flashing tool are included in \QAS.
-
-    \section1 Installing the \B2Q Image
-
-    Connect the DRIVE CX board to the development host via USB, and set it in
-    \e {recovery mode} by changing the position of J9 jumper on the board.
-
-    Then, run the flashing tool:
-
-    \badcode
-        cd <INSTALL_DIR>
-        sudo 5.7/Automotive/tegra-t18x/flash-nvidia/flash_device.sh
-    \endcode
-
-    After the installation is complete, replace the J9 jumper to its original
-    position, and restart the device. After reboot, check that the automotive
-    UI appears.
-
-    \section1 Setting up USB Access
-
-    \include b2qt-post-install-setup.qdocinc setting up usb access
-
-    \section1 Configuring a Device Kit in Qt Creator
-
-    After you have prepared the hardware, you must perform one final step
-    to set up the development tools in Qt Creator for your device. Run the
-    following command:
-
-    \badcode
-        cd <INSTALL_DIR>
-        5.7/Automotive/tegra-t18x/toolchain/configure-qtcreator.sh
-    \endcode
-
-    You are now ready to start developing for your device. For more information,
-    see \l{Building and Running an Example}.
-*/