path: root/src/doc/src/devices/qtee-intel-nuc.qdoc
diff options
Diffstat (limited to 'src/doc/src/devices/qtee-intel-nuc.qdoc')
1 files changed, 0 insertions, 75 deletions
diff --git a/src/doc/src/devices/qtee-intel-nuc.qdoc b/src/doc/src/devices/qtee-intel-nuc.qdoc
deleted file mode 100644
index 7213e3b..0000000
--- a/src/doc/src/devices/qtee-intel-nuc.qdoc
+++ /dev/null
@@ -1,75 +0,0 @@
-** Copyright (C) 2016 The Qt Company Ltd.
-** All rights reserved.
-** For any questions to The Qt Company, please use the contact form at
-** This file is part of Qt for Device Creation.
-** Licensees holding valid commercial Qt licenses may use this file in
-** accordance with the commercial license agreement provided with the
-** Software or, alternatively, in accordance with the terms contained in
-** a written agreement between you and The Qt Company. For licensing terms
-** and conditions see For further
-** information use the contact form at
- \page qtee-preparing-hardware-nuc.html
- \title Intel NUC
- \previouspage qtee-installation-guide.html
- Take the following steps when preparing an
- \l {}{Intel NUC}
- for \B2Q:
- \note It is important that you repeat the steps in this section after you
- update \SDK.
- The images containing the \B2Q stack for the device are included
- in \SDK. In these instructions, we prepare a USB device (a flash drive
- or an external USB hard drive) to boot from.
- \section1 Preparing a USB Boot Device
- For \B2Q, a USB drive of at least 2 GB capacity is needed.
- \include detect-sd-card-device-name.qdocinc instructions-usbdevice
- \section1 Installing the \B2Q Image
- \include common.qdocinc wizard
- Install the \B2Q image onto the USB device. First, ensure that no
- partitions are mounted:
- \include detect-sd-card-device-name.qdocinc unmount
- Then, use the following command to install the image:
- \badcode
- sudo dd bs=4k if=5.7/Automotive/intel-corei7-64/images/b2qt-embedded-qt5-image-intel-corei7-64.img of=/dev/<device_name>
- \endcode
- After the installation is complete, connect the USB drive to the device,
- power it on, and enter the BIOS setup (\b F2). Follow the instructions on
- \l {}
- {Operating System Installation for IntelĀ® NUC} for how to select the
- USB drive as a boot device.
- Press \b F10 to save your changes and exit BIOS setup. After reboot, check that the
- \B2Q welcome screen and/or demo appear.
- \section1 Setting up USB Access
- \include b2qt-post-install-setup.qdocinc setting up usb access
- \section1 Configuring a Device Kit in Qt Creator
- \include b2qt-post-install-setup.qdocinc configuring device kit linux
- You are now ready to start developing for your device. For more information,
- see \l{Building and Running an Example}.