diff options
Diffstat (limited to 'src/doc/src/devices/qtee-raspberry-pi.qdoc')
-rw-r--r-- | src/doc/src/devices/qtee-raspberry-pi.qdoc | 69 |
1 files changed, 69 insertions, 0 deletions
diff --git a/src/doc/src/devices/qtee-raspberry-pi.qdoc b/src/doc/src/devices/qtee-raspberry-pi.qdoc new file mode 100644 index 0000000..9a30dce --- /dev/null +++ b/src/doc/src/devices/qtee-raspberry-pi.qdoc @@ -0,0 +1,69 @@ +/**************************************************************************** +** +** Copyright (C) 2014 Digia Plc +** All rights reserved. +** For any questions to Digia, please use the contact form at +** http://qt.digia.com/ +** +** This file is part of Qt Enterprise Embedded. +** +** Licensees holding valid Qt Enterprise licenses may use this file in +** accordance with the Qt Enterprise License Agreement provided with the +** Software or, alternatively, in accordance with the terms contained in +** a written agreement between you and Digia. +** +** If you have questions regarding the use of this file, please use +** the contact form at http://qt.digia.com/ +** +****************************************************************************/ +/*! + \target Raspberry Pi Model B (embedded Linux) + \page qtee-preparing-hardware-rasberrypi.html + \title Preparing Raspberry Pi + \previouspage qtee-installation-guide.html + \nextpage qtee-building-and-running.html + + Take the following steps to prepare a \l{http://www.raspberrypi.org/} + {Raspberry Pi} for + \B2Q. + + \note Ethernet networking is required to connect the device to Qt Creator. + This means that the support is currently limited to Raspberry Pi Model B, which + includes an Ethernet port. + + \note It is important that you repeat the steps in this section after you + update \SDK. + + The image containing \B2Q stack for Raspberry Pi is included in the SDK, + ready to be copied to an SD card. + + \section1 Preparing an SD Card + + An SD card of at least 512 MB capacity is sufficient. + + \include detect-sd-card-device-name.qdocinc instructions + + \section1 Installing the \B2Q Image + + To write the image to the SD card, ensure that no partitions on the + SD card are mounted: + + \include detect-sd-card-device-name.qdocinc unmount + + Then, + + \badcode + cd <INSTALL_DIR> + sudo Boot2Qt-3.x/raspberrypi-eLinux/images/deploy.sh /dev/<device_name> + \endcode + + After the image has been deployed, insert the SD card, power on the device and check that + the \B2Q welcome screen and/or demo appear. + + \section1 Configuring a Device Kit in Qt Creator + + \include b2qt-post-install-setup.qdocinc configuring network device + + You are now ready to start developing for your device. For more information, + see \l{Building and Running an Example}. +*/ |