diff options
Diffstat (limited to 'src/doc/src/devices/qtee-raspberry-pi.qdoc')
| -rw-r--r-- | src/doc/src/devices/qtee-raspberry-pi.qdoc | 19 |
1 files changed, 7 insertions, 12 deletions
diff --git a/src/doc/src/devices/qtee-raspberry-pi.qdoc b/src/doc/src/devices/qtee-raspberry-pi.qdoc index b272f71..4340065 100644 --- a/src/doc/src/devices/qtee-raspberry-pi.qdoc +++ b/src/doc/src/devices/qtee-raspberry-pi.qdoc @@ -17,24 +17,19 @@ ** ****************************************************************************/ /*! - \target Raspberry Pi Model B (embedded Linux) + \target Raspberry Pi 2 Model B (embedded Linux) \page qtee-preparing-hardware-rasberrypi.html - \title Preparing Raspberry Pi + \title Preparing Raspberry Pi 2 \previouspage qtee-installation-guide.html \nextpage qtee-building-and-running.html - Take the following steps to prepare a \l{http://www.raspberrypi.org/} - {Raspberry Pi} for - \B2Q. - - \note Ethernet networking is required to connect the device to Qt Creator. - This means that the support is currently limited to Raspberry Pi Model B, which - includes an Ethernet port. + Take the following steps to prepare a \l{https://www.raspberrypi.org/products/raspberry-pi-2-model-b/} + {Raspberry Pi 2} for \B2Q. \note It is important that you repeat the steps in this section after you update \SDK. - The image containing \B2Q stack for Raspberry Pi is included in the SDK, + The image containing \B2Q stack for Raspberry Pi 2 is included in the SDK, ready to be copied to an SD card. \section1 Preparing an SD Card @@ -52,11 +47,11 @@ \include detect-sd-card-device-name.qdocinc unmount - Then, + Then, enter the following command to deploy the image: \badcode cd <INSTALL_DIR> - sudo 5.5/Boot2Qt/raspberrypi-eLinux/images/deploy.sh /dev/<device_name> + sudo 5.5/Boot2Qt/raspberrypi2-eLinux/images/deploy.sh /dev/<device_name> \endcode After the image has been deployed, insert the SD card, power on the device and check that |