1 files changed, 2 insertions, 26 deletions
diff --git a/src/doc/src/b2qt.qdoc b/src/doc/src/b2qt.qdoc
index 0a80f87..b2880bd 100644
--- a/src/doc/src/b2qt.qdoc
+++ b/src/doc/src/b2qt.qdoc
@@ -207,9 +207,7 @@
     a \B2Q welcome screen and/or demo. Then go on to the installation
     steps below.
 
-    \section1 5. Setting up Connection to Target Devices
-
-    \section2 5.1 Setting up USB Access to Embedded Android Devices
+    \section1 5. Setting up USB Access to Embedded Devices
 
     \e{If targeting only the emulator, this step may be skipped}
 
@@ -241,24 +239,6 @@
     system log files \c{/var/log/udev} and \c{/var/log/syslog} may
     provide relevant information in case of connection problems.
 
-    \section2 5.2 Setting up Network Access to Embedded Linux Devices
-
-    Devices using \B2Q for embedded Linux stack must be connected to a
-    wired network in order to be used with QtCreator. The devices are
-    setup to automatically configure a network connection using DHCP
-    and device specific hostname which is used by QtCreator to connect
-    to the device.
-
-    You can verify that the connection between QtCreator and the target
-    device is working correctly from the \c{Devices} configuration tab
-    in QtCreator.
-
-    Depending on the configuration on your network, connecting with the
-    hostname may not work correctly. In that case you can use IP address
-    for the connection instead of hostname. You can view the device's
-    current hostname and IP address from the "Launcher Settings" app and
-    setup the connection in the QtCreator's \c{Devices} configuration.
-
     \section1 6. Configuring a Device Kit in Qt Creator
 
     After the hardware has been prepared, there is one final step required
@@ -796,11 +776,7 @@
     \section1 Connectivity Issues
     \section2 I cannot connect to my hardware device via USB
 
-    See \l{5.1 Setting up USB Access to Embedded Android Devices}.
-
-    \section2 I cannot connect to my hardware device via network
-
-    See \l{5.2 Setting up Network Access to Embedded Linux Devices}.
+    See \l{5 Setting up USB Access to Embedded Devices}.
 
     \section2 adb fails with "error: more than one device and emulator"