From c56c9bc0107bced7635bc93edd8521f415e005c7 Mon Sep 17 00:00:00 2001 From: Leena Miettinen Date: Tue, 10 Dec 2013 12:26:21 +0100 Subject: Doc: edit the sections about preparing devices MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit Edit for grammar and style. Use standard wording in lists. Use active voice instead of passive voide. Use lists for all processes. Use the term "SD card" everywhere instead of "micro-SD card". Replace XXX with . Change-Id: Ie300dac911b42120de5e236676aa7b43c39f27d7 Reviewed-by: Topi Reiniö --- src/doc/src/b2qt-post-install-setup.qdocinc | 23 +++++++++++------------ 1 file changed, 11 insertions(+), 12 deletions(-) (limited to 'src/doc/src/b2qt-post-install-setup.qdocinc') diff --git a/src/doc/src/b2qt-post-install-setup.qdocinc b/src/doc/src/b2qt-post-install-setup.qdocinc index d1a6f08..ef93b3f 100644 --- a/src/doc/src/b2qt-post-install-setup.qdocinc +++ b/src/doc/src/b2qt-post-install-setup.qdocinc @@ -74,22 +74,21 @@ //! [configuring device kit] //! [configuring network device] - After the hardware has been prepared, there are final steps required - to set up the development tools in Qt Creator for your device. - - To do so, connect your device to network via ethernet cable and launch - Qt Creator. Then, + After you have prepared the hardware, you must set up the development tools + in Qt Creator for your device. Connect your device to the network via an + Ethernet cable and launch Qt Creator. In Qt Creator: \list 1 - \li Go to \b{Tools > Options > Devices} - \li Click \b{Add...} - \li Select \b{Boot2Qt Device} and Click \b{Start Wizart} - \li Fill in name of the device and network address. Device address can be seen from - \e{Launcher Settings} when device is running \B2Q demo - \li Click \b{Finish}. + \li Select \b{Tools > Options > Devices > Add}. + \li Select \b{Boot2Qt Device} > \b{Start Wizard}. + \li Enter the device name and network address. You can check the device + address in the \e{Launcher Settings} when the device is running the + \B2Q demo. + \li Select \b{Finish}. \endlist - You also have to configure the right device to be used for each \b{Kit}. + You also have to configure the correct device to be used for each build and + run \e{kit}: \include b2qt-post-install-setup.qdocinc steps for device kit -- cgit v1.2.3