From 90d8b98c3517d3339b6dc00e35a3975d23b00b8c Mon Sep 17 00:00:00 2001 From: Topi Reinio Date: Fri, 10 Jun 2016 11:46:54 +0200 Subject: Doc: Add documentation for NVIDIA DRIVE CX MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit Change-Id: Ib8d3f9ed1abd289e46c6e05102fccf5e91ad0513 Reviewed-by: Topi Reiniö --- src/doc/src/devices/qtee-drive-cx.qdoc | 65 ++++++++++++++++++++++++++++++++++ 1 file changed, 65 insertions(+) create mode 100644 src/doc/src/devices/qtee-drive-cx.qdoc (limited to 'src/doc/src/devices/qtee-drive-cx.qdoc') diff --git a/src/doc/src/devices/qtee-drive-cx.qdoc b/src/doc/src/devices/qtee-drive-cx.qdoc new file mode 100644 index 0000000..439d2a4 --- /dev/null +++ b/src/doc/src/devices/qtee-drive-cx.qdoc @@ -0,0 +1,65 @@ +/**************************************************************************** +** +** Copyright (C) 2016 The Qt Company Ltd. +** All rights reserved. +** For any questions to The Qt Company, please use the contact form at +** http://www.qt.io/contact-us +** +** This file is part of Qt for Device Creation. +** +** Licensees holding valid commercial Qt licenses may use this file in +** accordance with the commercial license agreement provided with the +** Software or, alternatively, in accordance with the terms contained in +** a written agreement between you and The Qt Company. For licensing terms +** and conditions see http://www.qt.io/terms-conditions. For further +** information use the contact form at http://www.qt.io/contact-us. +** +****************************************************************************/ +/*! + \page qtee-preparing-hardware-drivecx.html + \title NVIDIA DRIVE CX + \previouspage qtee-installation-guide.html + + Take the following steps when preparing \l {http://www.nvidia.com/object/drive-cx.html} + {NVIDIA DRIVE CX} for \B2Q: + + \note It is important that you repeat the steps in this section after you + update \QAS. + + The image containing the \B2Q stack for the device, as well as the + flashing tool are included in \QAS. + + \section1 Installing the \B2Q Image + + Connect the DRIVE CX board to the development host via USB, and set it in + \e {recovery mode} by changing the position of J9 jumper on the board. + + Then, run the flashing tool: + + \badcode + cd + sudo 5.7/Automotive/tegra-t18x/flash-nvidia/flash_device.sh + \endcode + + After the installation is complete, replace the J9 jumper to its original + position, and restart the device. After reboot, check that the automotive + UI appears. + + \section1 Setting up USB Access + + \include b2qt-post-install-setup.qdocinc setting up usb access + + \section1 Configuring a Device Kit in Qt Creator + + After you have prepared the hardware, you must perform one final step + to set up the development tools in Qt Creator for your device. Run the + following command: + + \badcode + cd + 5.7/Automotive/tegra-t18x/toolchain/configure-qtcreator.sh + \endcode + + You are now ready to start developing for your device. For more information, + see \l{Building and Running an Example}. +*/ -- cgit v1.2.3