From dfa19261f774c718e983a9d30e9e87710cd6a973 Mon Sep 17 00:00:00 2001 From: Topi Reinio Date: Wed, 9 Dec 2015 14:33:33 +0100 Subject: Doc: Mention that Ethernet connectivity only supports IPv4 Task-number: QTEE-979 Change-Id: I8b668c459670f83053127f3e037cbf32a0495291 Reviewed-by: Samuli Piippo --- src/doc/src/qtee-customization.qdoc | 2 +- src/doc/src/shared/b2qt-post-install-setup.qdocinc | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-) (limited to 'src/doc/src') diff --git a/src/doc/src/qtee-customization.qdoc b/src/doc/src/qtee-customization.qdoc index 272bc07..5604375 100644 --- a/src/doc/src/qtee-customization.qdoc +++ b/src/doc/src/qtee-customization.qdoc @@ -239,7 +239,7 @@ \section1 Using Network Connection for ADB By default, \B2Q uses USB cable for communication between device and Qt Creator. - On \B2QL, you can change the device to use ethernet network connection for the + On \B2QL, you can change the device to use ethernet network connection (IPv4) for the communication. To enable network connection, you need to modify file \c /etc/default/adbd located on the devices, and change value of \c USE_ETHERNET to \c 'yes'. This can also be done with \c adb, while the device is still diff --git a/src/doc/src/shared/b2qt-post-install-setup.qdocinc b/src/doc/src/shared/b2qt-post-install-setup.qdocinc index e73b8e7..4444dfc 100644 --- a/src/doc/src/shared/b2qt-post-install-setup.qdocinc +++ b/src/doc/src/shared/b2qt-post-install-setup.qdocinc @@ -83,9 +83,9 @@ \list 1 \li Select \b{Tools > Options > Devices > Add}. \li Select \b{Boot2Qt Device} > \b{Start Wizard}. - \li Enter the device name and network address. You can check the device - address in the \e{Launcher Settings} when the device is running the - \B2Q demo. + \li Enter the device name and network address (IPv4). You can check the + device address in the \e{Launcher Settings} when the device is running + the \B2Q demo. \li Select \b{Finish}. \endlist -- cgit v1.2.3