blob: fae5725469f8e9012657c71515324b17f383c4a0 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
|
/****************************************************************************
**
** Copyright (C) 2014 Digia Plc
** All rights reserved.
** For any questions to Digia, please use the contact form at
** http://qt.digia.com/
**
** This file is part of Qt Enterprise Embedded.
**
** Licensees holding valid Qt Enterprise licenses may use this file in
** accordance with the Qt Enterprise License Agreement provided with the
** Software or, alternatively, in accordance with the terms contained in
** a written agreement between you and Digia.
**
** If you have questions regarding the use of this file, please use
** the contact form at http://qt.digia.com/
**
****************************************************************************/
/*!
\target BeagleBoard-xM (embedded Linux)
\page qtee-preparing-hardware-beagleboard.html
\title Preparing BeagleBoard-xM
\previouspage qtee-installation-guide.html
\nextpage qtee-building-and-running.html
Take the following steps to prepare a \l{http://beagleboard.org/hardware-xM}
{BeagleBoard-xM} for
\B2Q.
\note BeagleBoard-xM is no longer supported in \SDK 3.0. It is still,
however, supported and tested under the previous 2.x versions.
The image containing \B2Q stack for BeagleBoard-xM are included in \SDK,
ready to be copied to an SD card.
\section1 Preparing an SD Card
An SD card of at least 512 MB capacity is needed.
\include detect-sd-card-device-name.qdocinc instructions
\section1 Installing the \B2Q Image
To write the image to the SD card, ensure that no partitions on the
SD card are mounted:
\include detect-sd-card-device-name.qdocinc unmount
Then,
\badcode
cd <INSTALL_DIR>
sudo Boot2Qt-3.x/beagleboard-eLinux/images/deploy.sh /dev/<device_name>
\endcode
After the image has been deployed, power on the device and check that
the \B2Q welcome screen and/or demo appear.
\section1 Setting up USB Access
\include b2qt-post-install-setup.qdocinc setting up usb access
\section1 Configuring a Device Kit in Qt Creator
\include b2qt-post-install-setup.qdocinc configuring device kit
You are now ready to start developing for your device. For more information,
see \l{Building and Running an Example}.
*/
|