blob: 439d2a44460a3860c4cad5eff69bc4f3e2bdd9f2 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
|
/****************************************************************************
**
** Copyright (C) 2016 The Qt Company Ltd.
** All rights reserved.
** For any questions to The Qt Company, please use the contact form at
** http://www.qt.io/contact-us
**
** This file is part of Qt for Device Creation.
**
** Licensees holding valid commercial Qt licenses may use this file in
** accordance with the commercial license agreement provided with the
** Software or, alternatively, in accordance with the terms contained in
** a written agreement between you and The Qt Company. For licensing terms
** and conditions see http://www.qt.io/terms-conditions. For further
** information use the contact form at http://www.qt.io/contact-us.
**
****************************************************************************/
/*!
\page qtee-preparing-hardware-drivecx.html
\title NVIDIA DRIVE CX
\previouspage qtee-installation-guide.html
Take the following steps when preparing \l {http://www.nvidia.com/object/drive-cx.html}
{NVIDIA DRIVE CX} for \B2Q:
\note It is important that you repeat the steps in this section after you
update \QAS.
The image containing the \B2Q stack for the device, as well as the
flashing tool are included in \QAS.
\section1 Installing the \B2Q Image
Connect the DRIVE CX board to the development host via USB, and set it in
\e {recovery mode} by changing the position of J9 jumper on the board.
Then, run the flashing tool:
\badcode
cd <INSTALL_DIR>
sudo 5.7/Automotive/tegra-t18x/flash-nvidia/flash_device.sh
\endcode
After the installation is complete, replace the J9 jumper to its original
position, and restart the device. After reboot, check that the automotive
UI appears.
\section1 Setting up USB Access
\include b2qt-post-install-setup.qdocinc setting up usb access
\section1 Configuring a Device Kit in Qt Creator
After you have prepared the hardware, you must perform one final step
to set up the development tools in Qt Creator for your device. Run the
following command:
\badcode
cd <INSTALL_DIR>
5.7/Automotive/tegra-t18x/toolchain/configure-qtcreator.sh
\endcode
You are now ready to start developing for your device. For more information,
see \l{Building and Running an Example}.
*/
|
