blob: c99c47251a1e09c00ba291cb5dd37c8927a1a2b8 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
|
/****************************************************************************
**
** Copyright (C) 2014 Digia Plc
** All rights reserved.
** For any questions to Digia, please use the contact form at
** http://www.qt.io
**
** This file is part of Qt Enterprise Embedded.
**
** Licensees holding valid Qt Enterprise licenses may use this file in
** accordance with the Qt Enterprise License Agreement provided with the
** Software or, alternatively, in accordance with the terms contained in
** a written agreement between you and Digia.
**
** If you have questions regarding the use of this file, please use
** the contact form at http://www.qt.io
**
****************************************************************************/
/*!
\target Raspberry Pi 2 Model B (embedded Linux)
\page qtee-preparing-hardware-rasberrypi.html
\title Preparing Raspberry Pi 2
\previouspage qtee-installation-guide.html
\nextpage qtee-building-and-running.html
Take the following steps to prepare a \l{https://www.raspberrypi.org/products/raspberry-pi-2-model-b/}
{Raspberry Pi 2} for \B2Q.
\note It is important that you repeat the steps in this section after you
update \SDK.
The image containing \B2Q stack for Raspberry Pi 2 is included in the SDK,
ready to be copied to an SD card.
\section1 Preparing an SD Card
An SD card of at least 1 GB capacity is sufficient.
\include detect-sd-card-device-name.qdocinc instructions
\section1 Installing the \B2Q Image
\include common.qdocinc wizard
To write the image to the SD card, ensure that no partitions on the
SD card are mounted:
\include detect-sd-card-device-name.qdocinc unmount
Then, enter the following command to deploy the image:
\badcode
cd <INSTALL_DIR>
sudo dd bs=4k if=5.6/Boot2Qt/raspberrypi2/images/b2qt-embedded-qt5-image-raspberrypi2.img of=/dev/<device_name>
\endcode
After the image has been deployed, insert the SD card, power on the device and check that
the \B2Q welcome screen and/or demo appear.
\section1 Configuring a Device Kit in Qt Creator
\include b2qt-post-install-setup.qdocinc configuring network device
You are now ready to start developing for your device. For more information,
see \l{Building and Running an Example}.
*/
|
