1 files changed, 52 insertions, 0 deletions
diff --git a/meta-boot2qt-distro/dynamic-layers/toradex-nxp-layer/recipes-qt/boot2qt-addons/qbsp-readme/mx8/README b/meta-boot2qt-distro/dynamic-layers/toradex-nxp-layer/recipes-qt/boot2qt-addons/qbsp-readme/mx8/README
new file mode 100644
index 00000000..b1f8b744
--- /dev/null
+++ b/meta-boot2qt-distro/dynamic-layers/toradex-nxp-layer/recipes-qt/boot2qt-addons/qbsp-readme/mx8/README
@@ -0,0 +1,52 @@
+To successfully set up the Boot to Qt software stack,
+follow the instructions in https://doc.qt.io/QtForDeviceCreation/qtdc-qbsp-installation-guide.html#.
+
+In 2. Installing Boot to Qt on Target Device, see also the following device specific instructions.
+
+
+2. Installing Boot to Qt on Target Device
+
+To flash the image, you can use either Toradex Easy Installer
+(https://developer.toradex.com/software/toradex-easy-installer#) or Qt's Flashing Wizard.
+
+
+2.1 Flashing with Toradex Easy Installer:
+
+When Toradex Easy Installer is connected to the Internet, it automatically provides
+the latest Boot to Qt image in its image list but that is not necessarily compatible
+with your Boot to Qt installation. When you flash with Toradex Easy Installer,
+you should always use the *.tezi.tar package that is included into the Boot to Qt
+installation.
+
+Flash the Boot to Qt image with Toradex Easy Installer as follows:
+
+1. If your target device does not have the pre-installed Toradex Easy Installer,
+follow instructions in https://developer.toradex.com/software/toradex-easy-installer#load-toradex-easy-installer#
+to load Toradex Easy Installer.
+2. Your Boot to Qt installation has the *.tezi.tar package under
+<Qt installation directory>/<Qt version>/Boot2Qt/<target>/images. Extract the package
+to an SD card or a USB flash drive.
+3. Flash the image from the SD card or the USB flash drive with Toradex Easy Installer.
+See https://developer.toradex.com/software/toradex-easy-installer#installing-the-images.
+
+
+2.2 Flashing with Qt's Flashing Wizard
+
+1. Use the RS-232 cable to access the serial terminal on Toradex board.
+2. Power on your device and press any key to stop the autoboot.
+3. Run the following command in U-Boot:
+
+ums 0 mmc 0
+
+4. Connect your device to the development host using USB On-The-Go (OTG).
+5. Use Flashing Wizard to flash the image to the device:
+   5.1 Launch Qt Creator.
+   5.2 Select Tools > Flash Boot to Qt Device, and follow the instructions in Flashing Wizard.
+6. Press Ctrl+C in the U-Boot console and run the reset command.
+
+Note: The u-boot is not updated when using the Flashing Wizard.
+
+For more information about flashing the Toradex devices,
+see https://developer.toradex.com/software/linux/linux-software/build-apalis-imx8-yoctoopenembedded-bring-up-image#emmc-boot#.
+
+Note: The Boot to Qt software stack supports only the v1.0B silicon.