Doc: preparing SABRE SD i.MX6Dual

Task-number: QTEE-842
Change-Id: I93b9178b201593c5c28c7e51ca16404a3509ed9f
Reviewed-by: Kalle Viironen <kalle.viironen@theqtcompany.com>

1 files changed, 0 insertions, 71 deletions

diff --git a/src/doc/src/devices/qtee-sabre-sd-imx6quad.qdoc b/src/doc/src/devices/qtee-sabre-sd-imx6quad.qdoc
deleted file mode 100644
index f462159..0000000
--- a/src/doc/src/devices/qtee-sabre-sd-imx6quad.qdoc
+++ /dev/null
@@ -1,71 +0,0 @@
-/****************************************************************************
-**
-** Copyright (C) 2014 Digia Plc
-** All rights reserved.
-** For any questions to Digia, please use the contact form at
-** http://www.qt.io
-**
-** This file is part of Qt Enterprise Embedded.
-**
-** Licensees holding valid Qt Enterprise licenses may use this file in
-** accordance with the Qt Enterprise License Agreement provided with the
-** Software or, alternatively, in accordance with the terms contained in
-** a written agreement between you and Digia.
-**
-** If you have questions regarding the use of this file, please use
-** the contact form at http://www.qt.io
-**
-****************************************************************************/
-/*!
-    \target SABRE SD i.MX6Quad (embedded Linux)
-    \page qtee-preparing-hardware-imx6sabresd.html
-    \title Preparing SABRE SD i.MX6Quad
-    \previouspage qtee-installation-guide.html
-
-    Take the following steps to prepare a
-    \l{http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=RDIMX6SABREBRD}
-    {Freescale SABRE SD i.MX6Quad} for \B2Q.
-
-    \note It is important that you repeat the steps in this section after you
-    update \SDK.
-
-    The images containing the \B2Q stack for SABRE SD i.MX6Quad are included
-    in \SDK, ready to be copied to an SD card.
-
-    \section1 Preparing an SD Card
-
-    An SD card of at least 1 GB capacity is sufficient.
-
-    \include detect-sd-card-device-name.qdocinc instructions
-
-    \section1 Installing the \B2Q Image
-
-    \include common.qdocinc wizard
-
-    To write the image to the SD card, ensure that no partitions on the
-    SD card are mounted:
-
-    \include detect-sd-card-device-name.qdocinc unmount
-
-    Then,
-
-    \badcode
-        cd <INSTALL_DIR>
-        sudo Boot2Qt-4.x/imx6qsabresd-eLinux/images/deploy.sh /dev/<device_name>
-    \endcode
-
-    After the image has been deployed, insert the SD card, power on the device and check that
-    the \B2Q welcome screen and/or demo appear.
-
-    \section1 Setting up USB Access
-
-    \include b2qt-post-install-setup.qdocinc setting up usb access
-
-    \section1 Configuring a Device Kit in Qt Creator
-
-    \include b2qt-post-install-setup.qdocinc configuring device kit
-
-    You are now ready to start developing for your device. For more information,
-    see \l{Building and Running an Example}.
-*/
-